18 w led lamp flashing how to return a responsibility
Where should be the power supply, power supply is generally in the inside of the lamps and lanterns, as long as you open it to see a plastic box, that is the power supply, you can put it in.
LED the stroboscopic formal product is not available. Considering the line not connected and lead to poor contact, so goods flashing. If the home is equipped with multiple inside, just a single flash, can open another hole to install the replacement, if other outfit also flash, is the problem of the hole line. Or dismantling of the flash to try other charges, if installed to another location also flash, there are some quality problems for the lamp can be determined
A common cause of LED lights flashing and the solution: Energy-saving lamps, LED lights will shine after power off, check the switch control is zero. If the correct wiring may refer to the following methods: The human eye can generally perceived frequency of 70 Hz light flashing, higher than the frequency does not perceive. So in LED lighting applications, if the pulse signal frequency is lower than 70 Hz low frequency component, the human eye will feel the shine. In the specific application, of course, there are many factors may lead to LED lights flashing.
For example, in an off-line low power LED lighting applications, a common power supply topology structure type is to isolate the flyback topology. In accordance with the "energy star" solid-state lighting standards from line 8 w LED drive GreenPoint ? reference design as an example, as a result of the flyback voltage stabilizer sine square wave power conversion did not provide primary offset constant energy, dynamic self-supply (DSS) circuit may activate and trigger light flashing. To avoid this problem, must enable primary bias to partial discharge in each half cycle, accordingly, need to choose appropriate constitute the bias circuit of capacitance and resistance value. If not stop flashing, is likely to be the light is broken, recommend replacing a try.
