A woodworking plane how to adjust the use of methods and skills?
In order to face the first "red line," the first high to low plane level: in the planning material before the first use of eye look at the convex and concave parts and the degree of wood surface preparation on planing, planing and then the protruding part of the roughly flat after the press planer planing long line. There are generally two ways of measuring wood by eyesight. One is to look at the plane of the vertical line, two lines in the same material, flat surface, no warping, if not straight; the two is facing the end of material, end plate flat with the right eyes close to the other end, to see whether straight. The general order is first, two, and later.
Recognize the exterior and the interior, distinguish the grain from the wood, and make no effort: the plane of the wood should be distinguished from the wood before planing, and then the direction of planing shall be decided so as to avoid the difference of the battle. Generally planing surface, it should be material to the root direction of the plane, planing, when inside, from the root to the material tip direction plane.
Adjust the cutter line, not crooked line is generally not inclined: rough planing planing cutter with fine line; planing planing planing planing and seams with a thick paper; planing planing planing bottom length can be exposed, in between.
A five foot three inches, a horizontal 85: it is said that if the plane is a foot long, three inches forward by five, basically is 1/3 of the total length of fixed planer, planer upper position, which made a 85 press down ratio between horizontal draw slope line to the lower port position of cutter. The amount to 5 6mm, get plane width.
A lying nine, not pushed; Li Wo eight, labor in vain: This refers to the slope in the planer cutter. When the vertical direction is one inch, the horizontal direction of nine points, equivalent angle is 49 degrees, suitable for cutting hard wood, push to dig more lively, general construction site use red pine, cork more, with a lying on a slope, the equivalent angle of 45 DEG C. If the use of standing down eight slope, it will be more difficult to use. Of course, in addition to some special purpose planing, planing slope also need appropriate changes, such as pull planing, slotting plane slope will be smaller; grooving, line planing, slope should be appropriate to increase a little.
