Bathroom marble wall with a paste technology
(1) process: primary processing, leveling line hanging on horizontal and vertical control lines * * inspection * color number pre woven patterns, mosaic stone installation * * repair gap * * clean polishing wax.(2) according to the division of the slate in the construction drawing, the horizontal and vertical dividing line of the stone plate is played on the base layer to carry out the pre arrangement of the stone slab.(3) according to the exact distance between the elastic line and the stone slab, at the plate joint, hang out the control line.(4) the control line is made of nylon wire or steel wire, in which the horizontal control line is connected with the safety.(5) a vertical control line is hung at both ends of the wall and in the middle part of each of the 4 channels.(6) slab installation:
(1) the partition of the wall surface is perfect, and the actual measurement on the spot, eliminate the error of the drawing, put forward the stone processing details.(2) classification of materials into the road, the walls of stone according to the installation sequence and color separation, safe place to facilitate the construction.(3) on-site hydropower in place and set up professional processing sites.
There are three methods for marble wall decoration:The first is wet paste, the first to play a layer of steel mesh on the wall, and then use concrete wet paste. This method is also relatively good adhesion, but relatively more trouble.The second is hanging, this method is to use the bolt on the wall fixed, then slotted in a block of stone, with a T shaped frame stone will be fixed, then the T shaped frame and bolted together, marble wall and wall of a certain distance, but fixed well. So if the location of the toilet, the most important way to paste the wall.The third method is relatively simple, is a direct paste. Generally divided into paste and paste. Surface paste method is applicable to thin stone, the thickness of 8m m, the weight and the wall is almost, can use special mortar paste. Point paste is the use of special stone glue, the point of the range can not be greater than 25cm, the amount of points can not be less than 3 to 4cm, the thickness of the glue in the more than 0.5cm, this method is used for slightly thicker stone. However, the direct pasting method is not suitable for the bathroom, because the bathroom is mainly light body wall, deformation, and the bathroom is often wet, a long time, easy to aging glue, it is easy to have an accident.
