I have a composite Warrior Dolomite hockey stick and dont like the blade curve. Can I heat the blade and bend it to the way I like? I have heard varying opinions on this.
I wouldn't do that, because you can weaken the blade if not done properly, or even snap it off in the section you had heated. You also run a risk of making the curve wrong in another direction (whether with too much angle to loft the puck, or too flat, or give it some sort of unusual and odd curve) that will mean another heating cycle. You should have checked the curve when you got it. Hockey supply stores do have pucks around, and people do use them for that purpose.
It's doable, but do not dunk it in water afterwards. I don't know how well you could do it with just a heat gun, and overall, I wouldn't try it. But it can be done. It's a lot easier to break a composite blade doing that then a wood blade. I guess if what you're doing is slight, it could be okay. I would use a blowtorch, and heat both sides of the blade. And bend it slowly. And let us know if it works.
If there's a diverse harm between the two sticks, you could heat temperature up the shaft the area the two products meet with a blow-dryer. you could then tug out the blade and replace it as you desire. If there is not any connection, real right this is what you do. reported off the present blade, yet no longer too a techniques; relatively till ultimately this is at a width approximately such as a minimum of a few subject of the shaft. Now, there could be a hollow interior different end of your stick. then you certainly take a option blade, heat temperature the glue and slide it into the hollow. enable it to dry, tape the sawed end (sand it down first if this is a sprint no longer uncomplicated) and you're solid to bypass! keep in techniques, a replaced blade heavily isn't in basic terms approximately as solid by fact the unique.
