Home > categories > Construction & Real Estate > Engineered Flooring > Cause of composite floor arching
Question:

Cause of composite floor arching

Home bedroom composite flooring recently damped arch particularly serious, the area is also growing, with the foot up to the water seepage, but the home did not seep water and the bedroom where there is no water leakage, the floor did not soak the water. The most serious arch is the place next to the door and the window, the middle of the place ok, basically no effect. Do not know what is the reason, is the floor back to the tide or with this year's weather often rain related? Home decoration has been a few years, this year only Huashu Shu makeup remover show off the situation. Question added: my house on the third floor, there is no room inside the heating, the family in addition to the toilet to take the tide of the tumbler makeup remover, the other room did not take the water, the family did not rain leaking. Two floors are assembled between the cracks around the place where the arch is the most serious. More

Answer:

The floor is mainly caused by the damp, but stepped on the water seepage should not be the cause of the tide may not pay attention to sprinkle water. It is advisable to have ventilation in sunny days.
If it is warm, it may be off off. There may be walls aging rainy day I think that should be the reason for this Thank you
I was selling the floor of the floor you said that I see a look that is certainly damp as a result is not good to say that may be too much rain with the oil because if it is so hot is not your fault directly to the solution it first The floor of the floor on the edge of the base line and then remove the wall of a slip board to cool down a few days a simple window ventilation is not useful because you have to step out of the water is sure to tide a bit too cold a few days The following dry after the trouble point because the floor from the arch that the original installation of the floor when the expansion of the expansion joints have no expansion joints is installed on the wall to the wall out of about 1 cm or so is the gap for the thermal expansion and contraction of the floor The damp will be full of swollen to the edge of the wall on the strength of a return from the arch ah back to the floor when the ride to find the saw in the side of the floor under the side of about 1 cm to press the basic no problem Do not know which one you are trying to make a lot of money if you have a place where you give me a best answer.
Installed a few years before the accident, the water came out, and certainly is leaking, and did not find does not seem to leak!

Share to: