CNC lathe tool holder can not be reset after the knife to do?
If you are unable to move the carriage to exit a and then try to use it to turn off the power first hand, or if not it may be burned (IF amplifier module in the boot state can rotate with hand screw it must be.). Look for an electrician, do not have to change the words.
If it refers to the size of the knife after the processing is not allowed that it is possible to damage the screw rod, have to find a fitter check. General coupling may be broken. A bit more serious is that the nut is loose or the check of the screw rod is broken, even the screw rod is bent.
If it is not normal because hit the reset knife out of data (control board NC normal output but blocking of the motor so cause can not be restored to the original position), this is the best of the carriage return the mechanical origin of the data after reset (reset)
