Does the car tire come within or without?
The, outside and "inside" that are marked on the tire wall need not be separated. They are not marked inside and outside, but for the convenience of inspection, the date is facing outwards.Tyre installation1. tire before installation, should carefully check the rim without distortion and deformation of tube leaks, there is no broken tyre bead, wall has no dirt and nail first, to prevent the installation after the fault in use.
7. inflatable not too fast. Because the inner soft and collapsible tube into the tyre after if suddenly a lot of inflatable tubes, may also fold before stretching is crushed, thereby causing damage to the tube. It is divided into two steps to install the inner inflatable, first filled in a small amount of gas, pause, then deflated, the folding part of tube flattening, pressure and then inflated to the provisions of the.8. for the sake of safety, in the official before inflation should be inserted in a thick steel bar in horizontal semicircular disc hole, locking ring and ring, and the ring towards the ground or other buildings, to prevent the lock ring, ring high speed pop-up causing casualties.9. in a sense, air pressure is the life of a tire. Therefore, it is necessary to inflate according to the standard stipulated in the technical manual, and the inflation pressure is not allowed to decrease in order to reduce vibration and cooling.
3. when installing the first inner lining and sleeve on the rim, the outer wall of the inner wall of the outer and inner tube are respectively coated with talcum powder, the tire side into the rim, the valve tube alignment hole rim, the inner tube from the gap into the rim and the rim, and from the rim the circular hole from the outlet door mouth, with the valve cap, and then install the tire on the other side. Pry into the last tread, pry with a pry bar and remain stationary, and another pry the tire rod into the small part of the gap between the rim and the tire edge, pry the tire into the rim. If necessary, you can use foot or hammer to cooperate with you.4. with tyre lever to pry into the tire, note the tyre lever cannot be inserted too deep, avoid punctured tube and pry off the bead bead.5. tire rim loading, should check and adjust the valve and align the wheel hub, inflated tire rotation, the valve position adjustment.
2. some tire without balance marks, glue it with red, yellow, white, light blue color, mouth, and made a arrow shape, etc., in the side of the tire vulcanization, it says here is the lightest parts of tyre. When installing the inner tube, the valve face shall be directed against this mark to keep the balance of the tire running at high speed
