Dongguan locker lock how to change?
After installation lock: the handle spring into the rear lock handle handle hole, a small square shaft into the knob hole, large square shaft into the lock cylinder fork hole. Will be the rear lock handle handle hole and the generous shaft, small square shaft and cylinder small square shaft hole alignment, close the rear lock
Before installing the front cover: Put the handle spring into the front lock handle hole The large square shaft is put into the cylinder, and the front cover handle hole is aligned with the generous shaft, the lock hole and the lock head, and the front cover is closed. Plug-in: Plug the locking cable into the corresponding socket on the front cover.
Start the door lock by the corresponding relationship. Install the lock cylinder, insert the lock cylinder 11 into the door hole, fix it with screws, and insert the lock wire into the door inside. Install the lock: Screw the lock head 14 into the lock hole and twist the lock head to the height of the front cover
Choose the door with the same direction of the lock body; check the parts are complete, and power to try the door
Upper fixing screw: Adjust the front and rear locking positions and tighten the four locking screws. Fixed lock: adjust the lock position, so that the end face and front lock level, keyhole in a vertical position, the lock head screw tightening. Install the battery cover: Insert the battery compartment into the lock cylinder compartment.
