Home > categories > Rubber & Plastics > Rubber Rollers > Dust free corn sheller how to dust?
Question:

Dust free corn sheller how to dust?

Dust free corn sheller how to dust?

Answer:

The threshing machine is equipped with a 3 kW motor and a blower. The steering and stopping of the motor and fan are controlled by a reverse reverse switch. The motor is fed clockwise counterclockwise to Corn Cob, mainly for the launch of Corn Cob and troubleshooting, fan for off chip, slag generated in the threshing. The motor belt wheel through a belt wheel, CVT pulley, synchronous gear, the cutter disc, special-shaped cutter rotary cutting Corn Cob work, adjust the steering handle, the cutter speed change; another transmission line is composed of two grade V-belt wheel, worm gear drives three sets of rotary drum.
The installation of a small simple dust catcher is mainly the principle of bag filter. Dust threshing device, which is composed of vacuum tube, centrifugal blower, dedusting duct, vacuum tube opening at the discharging port of the lower hopper, dust and impurities, the suction produced by centrifugal blower can be sucked out mostly by the threshing. The dust removing air duct is arranged at the designated place to eliminate dust pollution, protect the health of the staff, improve the working environment, and improve the cleanness of the threshing corn.
The drum is equipped with a compression spring, rubber roller, plastic roller, rubber roller rotates among the two groups (feed Corn Cob), rubber roller is gripping, conveying and Corn Cob function, the spring can be adjusted properly according to the distance between the two rollers Corn Cob diameter, in order to adapt to the different diameter of corn threshing stick the requirements of. A set of plastic rollers can hold the corn cob to the waste bin. Lubricate cutter and cutter head using drip type oil cup, lubricating oil with olive oil. In order to make the structure compact, a plastic bearing is arranged in the cutter head. The plastic bearings rotate on the shaft.
The main part is the lubrication of worm and worm and worm gear, worm plastic bearings, with open drive, lubrication with butter; plastic bearings require running lubrication, the needle type oil cup standard, volume 200 ml, and the end is equipped with a drip tubing, tubing is connected with an oil groove on the bolt. The connection end and bearing.

Share to: