Is thickness a major concern with engineered hardwood flooring? My subfloor is 3/4 ply.Here's an example.
Thickness and the coat(s) of urethane that actually protect the top is what is the most important. Pro.. Engineered you do get a high quality straight board, easier for the average DIY job. Not so in all 3/4 flooring. Theses you some times fight a bit to install and keep straight. Pro.. you can redo 3/4 flooring, usually several time. Con.. Not always with 3/8 since its a veneer, you can do it once usually. 3/4 flooring is fine for both as long as its flat. 3/8 engineered with a harder wood on top can out last oak..So check the janka rating for hardness. Most depends on the over all care you put into each flooring. Any questions you can e mail me through my avatar. GL
I really don't now much about this, but this site also helped me a lot goo.gl/dGD8qO
The thicker products are always better. Also, the thicker the top wear layer is the better. The top wear ;layer will determine how many times the floor can be refinished in the future. Thicker floors also tend to feel more solid when walked on.
With subfloor only 3/4 thick, I'd recommend the 3/4 inch finish flooring. If you used 1 1/16 subfloor, then I'd say look how thick the wear layer (top layer) of the new flooring is, then decide. I personally use 3/4 inch thick solid oak finish flooring in my homes, so it will last about as long as an anvil.
3 8 Engineered Hardwood Flooring
