Excuse me, how can you install the laser tube of the laser equipment?
When the first oxide layer of the anode and the cathode terminal of the 3. terminal polished off the laser tube, and then use the metal thin copper wire two wiring column wrapped on the tin, then tin anode wire butt welding laser tube. Requirements: no burr. The laser tube anode terminal by silica gel seal 705 and all the lines, water pipes can be fixed in order.
he installation of the water pipe of the laser tube should follow the principle of "low in and out": the water inlet is facing down and the water outlet faces upwards (as shown). When installing the rubber hose, a small amount of water can be applied at the water inlet so that the installation is convenient
Laser display tube is 1# mirror (near the cathode cathode end to end)
laser tube through water requirements: water layer all over the water, the upper part can leave a small amount of bubbles, and lens water cooling tube, the water surface must cover more than 90% of the mirror
