Excuse me, how to install the LED lamp?
Installation installation method 3 inch downlight LED you can refer to EPCOL, thank you! Hope to be helpful to youA: check the manual, to understand the basic features of LED lamps:Two: installation of lamps and lanterns preparation work:Turn off the main power supply. Make sure the power is off and safe operationLook at the wiring, check the upper part of the ceiling line, the line pipe, if necessary, pull the wire to the place where the lamp needs to be installedPay attention to the groove, without sharp edges and burrs, so as not to scratch the power cordDetermine the line diameter of the cable according to the load,
Pull over the protective device for the lamp, and note that the wire is configured to prevent the conductor from becoming brittle or rodent bite
Lamps shall not be covered by any flammable substanceThe wiring of the lamp should not be close to the radiator, and should be avoided as far as possible
According to the instruction, the hole is opened on the ceiling with an openerThree: after opening the hole, pull out the wire, then connect the drive and the lampPay attention to the positive and negative poles of the lamps and lanterns, the ground mark of the lamps and lanterns, and correctly install the ground wirePay attention to the distance between the fixtures and the wall or the wall so as to facilitate the heat dissipation of the lamp
