Fluorescent lamp double lamp tube wiring method
Hello, first of all make sure you double tube fluorescent lamp is electronic or inductance, the inductance ballast on the side of the light directly to the crural line received a ballast, ballast another terminal from the actuators to a power supply, another lamp crural line also from the actuators to a power supply,
Leds that do not normally require special orders are mostly built with built-in power, which is directly available. Most can only need to remove the starter on the traditional stent line (is a cylinder bracket highlighted below) mount tubes can be used, if not yet so could you use the stent is a relatively new "electronic" will be a little trouble need you open the stents to get inside the ballast also take off to the inside of the line directly connected to the utility, LED bulb is directly at the mains. Of course, if you understand the circuit and you're not afraid of trouble, it's advisable to remove the "regenerator", because the "ballast" is a power drain.
Is ok, if the electronic ballast, take a look at is a of the area, or area of two, if is one of the region, the four lines of the same light foot directly connected to the ballast end (the end of the four terminal) ballast directly connect the power cord is ok, on the other side of the ballast area 2, the light of the light feet a line connected to the ballast, on the other side of the ballast connect the power cord is ok!!
