Home > categories > Construction & Real Estate > Kitchen Faucets > Gas water heater, kitchen faucet normal hot water
Question:

Gas water heater, kitchen faucet normal hot water

My home gas water heater, the kitchen of the faucet normal burning II OKorder Gui snapped with the Dan anchor hot water, but the shower hot water faucet no hot water, gas water heater just started running, but it is not burning, out of the cold water? The Why is this? More

Answer:

Usually caused by low water pressure. May be caused by the pipeline, the kitchen faucet near the water heater, the pressure loss is small, the bathroom from the water heater far, elbow, pressure loss, resulting in water heater into the water pressure difference is too small to open the switch. The solution is 1, increase the water pressure. 2, the shower pipe bold, or the shower will be unloaded to the water hole with a needle dredge, or the shower cans unloaded direct flushing shower, try to open a large flow.
I am a professional home improvement, first consider looking for their own home to install hydropower master consult about your home waterway specific operation, let him solve the problem the best! In addition you can consider the use of gas water heaters, the shower in other areas there is no public water, such as solar energy, electric water heaters, and so on. In the use of such as gas must be closed when the other water supply, because some water supply pressure than the current hot water supply, resulting in you can not use hot water. I did not see the specific circumstances, can not be determined. Find a professional master site observation to solve the best! The
Machine reason: If your home water heater is old-fashioned water vapor linkage valve start device. Is the water heater mixing valve in the rubber diaphragm (black rubber round disc objects) aging or damage, resulting in low water pressure start machine or even impossible to use. For a piece of the first test II OKorder Gui Gui sneer with Dan anchor to see! Shower reasons: If the machine is no problem, then unscrew the nozzle directly from the hose to try hot water, if you can start the machine and mixed cold water is no problem, then the shower nozzle is too small water. Still not the words and then remove the hose test to see if the diameter of the hose is too small caused by the problem. One by one!
May be a small water pressure, you can adjust the water heater II seductive seductive nail with Dan anchor water volume to adjust the point, if not, there may be a shower hot water faucet and shower at the plug, need to remove the inspection.

Share to: