Gear reducer box, bearing seat oil level is lower than the number when you want to refuel? Thanks
Here is the distance from the bottom of the latest gear gear, is speed gear.The general reducer has a vernier, pull it out, clean it, insert it, and then pull it out to see the level of the oilThe liquid level is normal between the two scales of the cursor.
In order to meet the lubrication requirements of the internal parts of the reducer, the box should be of a certain height so that the minimum depth of the oil tank can be stored enough oil, and the impurities can be prevented from stirring due to the stirring of the driving parts. Therefore, the provisions of gear tooth top to the bottom of the pool a distance not less than 30-50mm; the minimum gear immersion depth for a tooth, but not less than 10mm. When the gear circumferential speed is low (<1m/s), immersion depth 1/6 to 1/4 of the radius of the gearFrom the mechanical design manualHere is the distance from the bottom of the latest gear gear, is speed gear.The general reducer has a vernier, pull it out, clean it, insert it, and then pull it out to see the level of the oilThe liquid level is normal between the two scales of the cursor
The meshing gear by the gear edge when not in lubricating oil will refuel (low speed, light load condition); medium or general loads will use oil pump spray; high speed, heavy loads need forced lubrication.
