Granite Marble with what medicine is polished
1, the construction process: stone surface finish surface cleaning → stone gap marble glue repair → overall ground grinding 6-7 times → ground drying → ground crystal treatment (K2, K3 syrup) → overall ground conservation (K1 syrup) → ground Clean up.
2, the stone surface to complete the surface clean up: the stone before the crystallization of the ground processing, paving finish the overall surface formation, no color, each stone between the diagonal flush, the ground to clean up the whole, with dry and clean to drag clean, No sand on the ground, impurities.
3, stone gap marble glue repair: stone surface after the completion of the overall clean-up, with marble glue on each piece of stone above the small spots to repair, first of all the original damaged surface with the stone color of the marble glue to repair. And then use a special stone sewing machine on the original stone installation of the seam in the re-neat cutting slit, so that the width of the gap changed almost, and then close to the stone color of the marble glue to fill it (Note: If the past has been done in the seam Processing without the need for new openings). Venom glue must be repaired after the glue can be done under the next process.
Marble polished: Marble finish 1, the main material: K1, K2, K3 crystal agent. K1 Potion is a stone crystal mirror agent, suitable for darker marble, K2 syrup is a stone surface plus hardener for the stone surface plus hard plus light, the formation of protective film on the surface and crystal mirror. K3 is made of durable natural wax resin, can form a high gloss on the surface of stone, can repair stone scratches, lasting effect, but also has anti-skid performance.
The overall ground grinding: to be dry after the marble glue, the use of grinding machine on the overall ground polished, the overall horizontal grinding, focusing on grinding between the stone joints (stone between the diagonal) and near the wall, decorative shape, Shaped shape of the edge of the edge, to maintain the overall stone surface formation, to complete the first pass of the polished, re-marbled rubber caulk, caulking to complete the second grinding, and then with stone renovation machine with steel stone water mill by the rough To the fine, (150 mesh, 300 mesh, 500 mesh, 800 mesh, 1000 mesh, 1500 mesh, 2000 mesh), a total of seven times to complete the polished finish the overall flat surface, smooth, and then use steel wool polishing, polishing design The required brightness (70 degrees), there is no obvious gap between the stone.
