i installed a new pump don't know how to increase water pressure and to what what pressure it should be set
This is very simple i would sugest the pressure to be set betwene 60 to 70 NO MORE THAN 70. 1. turn off power to pump (ether the circut breaker or a switch near the pressure switch) you dont want to weld the wrench to the switch. 2. remove the cover to the pressure switch its self (usly one #2 phillips screw) 3. now you will see 4 wires under some sloted screws nearest to the front of the switch, behint that is 1 or 2 bolts with a spring and a nut. 4. if you see 2 bolts you will want to turn the nut on the larger one to the right. you will want to tighten it about 1 to 2 full turns. (the same goes if there is only one bolt also) 5. now open the valve that is on the tank untill you here the switch click. then close the valve. 6. turn the power back on tio the pump and watch the pressure gauge on the tank. i DO NOT RECOMEND MORE THAN 70PSI. 7. if it goes over the pressure you want repete steps above exept loosen the nut in about 1/4 to 1/2 turns untill you reach the desired pressure 8. if it does not reach your desired pressure then you do the same thing exept tighten the nut in 1/4 to 1/2 turns untill you attain your desired pressure. 9. when the pressure is reached, replace cover so you dont risk rusting the contacts. if you need more help feel free to email me. and i will assist you in any way that i can.
