Home > categories > Rubber & Plastics > Plastic Pipe Fittings > Hot melt connection method of PE-RT plastic pipe and the matters needing attention?
Question:

Hot melt connection method of PE-RT plastic pipe and the matters needing attention?

Hot melt connection method of PE-RT plastic pipe and the matters needing attention

Answer:

3 the end face of pipe and pipe must be clean, dry and oil-free;4 use calipers and suitable pens to measure and mark the depth of hot melt at the end of the tube.5 when welding elbow or three way, according to the design drawing requirements, should pay attention to the direction, in the pipe fittings and pipe in the straight direction, with auxiliary sign mark its position;
When the heating time is reached, the pipe and the pipe are removed from the heating sleeve and the heating head at once, and the rapidly rotating straight line is inserted uniformly into the marked depth, and a uniform flange is formed at the joint;
When the connection is made, the pipe end without rotating is inserted into the heat sleeve to be inserted into the marked depth, and at the same time, the pipe fittings without rotating are pushed on the heating head to reach the designated mark. Heating time should meet the requirements of the above table (also according to the provisions of the manufacturer of hot melt tools);
To cut the pipe, the end face must be perpendicular to the axis of the pipe. The general use of the pipe or pipe cutting shear pipe cutting machine, if necessary, use a sharp saw, but after cutting the pipe section should remove burrs and burrs;
The hot melt tool is connected to the power supply and can start operation until the working temperature indicator is bright;

Share to: