Home > categories > Machinery & Equipment > Pavers > How can I make the paver go straight 5
Question:

How can I make the paver go straight 5

I would like to ask after the on-line painting! How to pave the paver?! How can I make the paver go straight?

Answer:

Side of the paver to tie a bent wire (90 degrees), one end of the alignment (painted), looking at the end of the wire to grasp the steering wheel, it will not be biased.
On the first floor is too generalThe two floor refers to the automatic operation principle of the paver (by the way, the walking sensor is mounted on the wheel side reducer, not the walking motor). Moreover, the output pulse current is entered ECU operation, through the CAN bus transmission to the walking pump solenoid valve, by the electromagnetic valve to accept the current size to change the pump body swashplate control flowThe third floor is not quite rightIn fact, this problem is very simple. After the paver is in place, the indication chain on the direction indicator is aligned with the reference line painted on the road. In the construction process, paving opportunities automatically adjust the track error on both sides, but not absolute line, to the current T8620 as an example, the factory requirements of error is 100M, within the line error is not more than 0.5M. So even in the linear time spreading hand correction direction, just to remember: regardless of the direction and deviation of datum line number, school certificate direction, using small direction correction, that is a little, to avoid large direction. Also, when you indicate the link near the baseline, remember to return the direction (that is, to reverse the direction), or you'll always have a S on the side of the road.
Paver each walking motor is installed on the speed sensor, automatic control hydraulic pump output current through the pulse signal sensor is given, as long as it is on both sides of the track tensioning, the flat surface of the working conditions, can automatically go straight.

Share to: