How can the hose of natural gas be connected to the water heater?
Both ends of the hose nut with inlet joint head directly said water heater, the key is the nut inside with sealing ring can not forget the good, but also to the right, after tightening will not leak, then good with soap and water leak, do not bubble. But you must point out that the safety requirements can not be connected to the general hose, should be connected to the hard tube (Bai Tieguan), temporary answer, we must pay attention to safety.
One end is connected to the water heater, the other end is connected to the gas pipe, and the other end of the gas pipe needs to be equipped with three through. Are you installing it yourself? Why don't you find the man who installed the water heater to put you through? Suggest that you still find professionals to connect, so that relatively safe. Hope to be of help to you.
It should be noted that when the nut is installed, pay attention to each nut must have plastic or rubber soft gasket, gasket must be flat, it plays the sealing role of the joint of the pipe joint.
The gas source is connected with a gas water heater by using a flexible stainless steel bellows, and the ends of the pipe are pressed into bell mouths by special tools, and two movable nuts are pre sheathed. Connect one end of the pipe to the outlet of the gas meter (tighten the nut), and the other end is connected to the gas inlet of the heater (screw another nut) so that the connection between the gas pipe and the water heater is completed.
