How can the laser level adjust the height of the horizontal line?
Seems to only be adjusted with a tripod, there is no other way
To increase the height, you can use three tripods, as long as the leveling instrument can be used on the line.
You can fix the level on the three stand and adjust the height of the horizontal line by adjusting the height of the three leg.Laser level meter operation mode:When measuring, the working surface of the level instrument is close to the tested surface, and the reading can be carried out until the bubble is completely stationary.The graduation of the level is based on the slope value of one meter as long as the actual tilt of the length of L is calculated by the following: the actual slope = the value of the division *L*, the number of deviationsIn order to avoid the measurement error caused by the zero position of the level instrument, the zero level of the level instrument must be checked or adjusted before use.Level zero calibration method: the horizontal instrument is placed on the base of the stable and approximately horizontal plate (or machine tool guide rail). When the bubble is stable, the end is read at the end, such as the left end, and zero. Then turn the level of 180 degrees, still placed in the original position of the plate, to be stable after the bubble, still in the original one (left) readings A, the level of zero error is two points A grid. If the zero error exceeds the permissible range, then adjust the level zero adjusting mechanism (adjustment screw or nut, the error is reduced to zero within the allowable value. The nut shall not be turned freely for the screws which are not specified.
