How can the TV signal receiver be installed to watch TV?

Answer:

Then the satellite receiver on the remote key information (some machine is key, then the TV star) should have two signals, a signal strength of a signal quality, signal strength display is pan (high frequency tuner) and satellite receiver is connected with the state, if it is zero should check the connection between the receiver and tuner has no problem (that is, the white line is not good, even if there is a percentage) displayed on the OK, the next step is to see the signal quality, its line of action shows the quality of the signal (i.e. not pan alignment)

There is a white point (coarse and cable length, one end is connected with the tuner (as) on the other end of the pot), then the receiver back. There is also the line to receive the TV, is the AV audio and video cable, as long as the line color receiver and TV on it. The wiring is completed, turn on the TV and satellite TV receiver power supply, will be transferred to AV state (press the remote controller or television video (AV), then there should be a key) TV receiver of satellite images (but not necessarily the TV show)

If the alignment should show the percentage, in general more than 60% (the size of quality high and low, different regions of different pot but at least should be higher than 35%) and should also have a TV show, if no TV shows no signal, the signal quality is beating between 3%-4%, the pan doesn't aim at the satellite, then look at the next step. Adjust the direction of the pot so that it is aligned with the satellite. The following method is used to adjust the azimuth angle (that is, the angle of the pot at the horizontal position, how many degrees south to the East) Move around the pan position, adjust the position of both the upper and lower adjusting pan (i.e., elevation) but also to stare at the change of signal quality on TV, such as signal quality to the maximum fixed position and the pot does not move, the debugging process must be careful, patient. You can slowly adjust the azimuth angle at the elevation angle. When the quality of the signal is the maximum, the program can be searched. Wish you success。