Home > categories > Electrical Equipment & Supplies > Fuse Components > how do i check the electrical system on a 1997 KX 60 dirt bike to determine which component is keeping it from?
Question:

how do i check the electrical system on a 1997 KX 60 dirt bike to determine which component is keeping it from?

i have determined there is no spark on my sons dirt bike and i have already eliminated the kill button but need to know how to check the coil,stater and CDI box to determine which one has failed.i dont want to go purchase all 3 if i can check these with a simple volt meter or test light.I know the basics of how the system works and know for sure the issue is not with the spark plug or a broken wire since i have traced down all wiring to maks sure it wasent that simple of a fix.

Answer:

Assuming the chain and sprockets are in stable condition, approximately halfway between the front and rear sprocket the backside portion of the chain ought to circulate vertically between 25-40mm while status immediately without-one sitting on the bike, no rely if it is greater beneficial than that it may be adjusted till the slack is actual. If there is important lateral stream or the adjusters are on the minimize or any tooth are broken on the sprockets the two the sprockets and the chain must be replaced. The marks on the eccentric adjusters are publications in elementary terms and should no longer be depended on as completely precise. to make optimistic the two the wheels are in an analogous direction use 2 parallel planks the two area of the bike.

Share to: