Home > categories > Electrical Equipment & Supplies > Power Cables > How do I reseat the hard disk data and power cables?
Question:

How do I reseat the hard disk data and power cables?

Hi. I just purchased a hp slimline S3420F used from OKorder. (dumb move, I know) Anyway it worked for a few days and now it won't turn on. The power supply light on the back is one but the computer won't come on. I was looking in the trouble shooting guide and one thing that is suggested is to reseat the hard disk data and power cables. It says for instructions to refer to a manual that I can't get because it's on my computer. I am on a public computer now and can't upload the manual to this computer. I switched the voltage to 230 and back to 115 real quick and that worked once. Probably just a coincidence. Now it just won't boot at all. LIke I said, the green power supply light on the back of the computer is on. I can read replies from my cell phone so perhaps someone can give me some ides what to do. I'm sure the answer lies in taking it to a repair shop. :(

Answer:

i'm assuming which you have a computer computer. in any different case they does not have instructed you that. ok, skill off; take the area panel off and you will see the motherboard, adapter taking part in cards, disk drives, and skill grant. the skill grant supplies you countless working voltages to the equipment by skill of skill of distinctive coloured wires. you will see they bypass to the countless aspects in the equipment. you have 2 or extra drives on your equipment and you'll be the optical (cd/dvd) power. The plug with the crimson yellow and black leads are the skill leads. pull that out and reseat it. it might desire to be comfortable so use care. in case you have an IDE no longer easypersistent it might desire to have a similar plug. If it rather is sata it rather is going to likely be a flat cable. the cable that passes information to those drives would be the two a eighty conductor flat ribbon cable or a sata cable it rather is a lot smaller;(reseat) get rid of and replace those. final and the single's you % to be maximum cautious with are the cables to the motherboard itself. in case you stick to the cables from the drives, you will see the place they terminate on the motherboard. Use warning right here to verify you do no longer positioned undue rigidity on the motherboard. additionally in any respect situations attempt to maintain in touch with the equipment case to keep away from static discharge.
Re-seating is nothing more than unplugging a connection, then plugging it back in. Your real problem sound related to the 230/115 switch, if not the power supply itself.

Share to: