How do Morse taper shanks connect the milling cutters?
With Morse taper shank by friction torque, such as the square groove said above can also increase the moment, you can in a car outside the front end of the main shaft thread, then do a special card big nut in the handle, the handle mounted to the spindle when the nut on the shaft to prevent the handle off, anyway. You are such a simple machine, can be installed on your machine and power is not large, it should be more insurance is relatively simple, can be like that for drilling oblique iron unloading handle, even if you use the 7:24 taper shank can also be installed
Milling cutter, cutter head and straight milling fixture can choose, only choose the milling cutter not by you, because to be loaded to a milling machine, so to match with the spindle hole milling machine, milling machine spindle hole taper is what, do what taper. Most of the large milling machines are 7 to 24 taper, and most of the small milling machines are Morse taper, but there is an internal thread hole behind the handle of the milling cutter, and the size of the internal thread must match the thread of the suspension screw used by the milling machine.In accordance with this cutter, the cutting force distance is large, special milling machine spindle hole must use 7 to 24 taper, 7: 24 taper also has several specifications. Is it for 2 or 3? Spindle diameter, please.Never use Morse taper
Milling cutter, cutter head and straight milling fixture can choose, only choose the milling cutter not by you, because to be loaded to a milling machine, so to match with the spindle hole milling machine, milling machine spindle hole taper is what, do what taper. Most of the large milling machines are 7 to 24 taper, and most of the small milling machines are Morse taper, but there is an internal thread hole behind the handle of the milling cutter, and the size of the internal thread must match the thread of the suspension screw used by the milling machine.In accordance with this cutter, the cutting force distance is large, special milling machine spindle hole must use 7 to 24 taper, 7: 24 taper also has several specifications. Is it for 2 or 3? Spindle diameter, please.Never use Morse taperThe taper of the inner hole at the front end of the spindle is matched with the dimension, the shaft is hollow, and the screw rod can be inserted through the screw rod to lift the cutter rows. Single bevel transmission force is insufficient, so there are two rows of connection end symmetric square groove in the spindle and milling cutter, and the cutter row match, put two pieces of limiting block to increase torque.
