How do you drill a sharpening bit?
By the back edge grinding behind. This is the slow grinding of the entire flank from the edge of the bit. It is easy to dissipate heat and grind. Based on the formula one or two to consolidate stability, this bit can be gentlyContact grinding wheel, a small amount of grinding, grinding, to observe the uniformity of the spark, to adjust the size of the pressure, and pay attention to the cooling of the drill. When the cooling start again after grinding, to set the position of the one or two formula,This is often difficult to master in the beginning, often involuntarily change the correctness of its position.Formula four: "the next swing tail don't tilt." This action is also very important during the sharpening of the drill, and the students often change the "up and down" into "up and down" in the process of grinding so that the other main blade of the drill is destroyed. withThe tail of the drill can not be raised above the horizontal center line of the grinding wheel, otherwise it will cause the edge to be dull and can not be cut.
Grinding machine with a bit grinding, you can, our company is using the Muller machine drill grinding machine, grinding effect is very good.
The drill shaft is slanting out of the front angle.." Here is the relation between the axis of the drill bit and the surface of the wheel. "Frontal angle", that is, the vertex angle of 118 degrees + 2O half, about 60 degrees, this position is very important, directly affect the top of the drillAngle size and main cutting edge shape and cross edge angle. To remind students to remember a commonly used 30 degrees, 60 degrees, 90 degrees triangular plate angle of 60 degrees, students easy to master. A formula and formula two refers to the relative position of the grinding beforeThe two should take overall consideration, and don't neglect to set the oblique angle in order to settle the edge of the blade, or ignore the edge of the blade in order to set the oblique axis. These errors are often present in actual operations. At this point the drill is in the correct positionPrepare the contact grinding wheel.
The blade is fixed against the wheel surface." This is the first step between the bit and the grinding wheel, and it is often the students who have not cut the edges of the blade, so they start sharpening on the grinding wheel. It must be hard to wear. The blade here"The mouth" is the main cutting edge, and the "cut out" means the main cutting edge of the grinding part is in the horizontal position. "Wheel surface" refers to the surface of the grinding wheel. "By" means slowly moving closer. The drill cannot contact the grinding wheel at this time.
