How do you make the faucet HOSE?
There must be a thread on the pipe, which is where the faucet is at home. Usually 25*1/2 or 20*1/2 wire. Center with a 15 copper outer wire or stainless steel outer wire to connect to your hose on the OK. The pipe won't pick up without a thread.
Furthermore, adjust the pressure to take machine embossing mold elastic, put a head to the embossing (embossing hose is six cap and braided hose connection the stainless steel cap). Not too tight not too loose as copper core, embossing mold need to reset, just like the other end in embossing. The hose will be fine. It's only packed. Pointed hose (single hole, hot water hose) 40CM, 50CM, that's hard to say. It's entirely cut by the length of the pointed tooth. Pointed teeth have 28 heads, 32 heads, 38 heads, 42 heads and 100 heads. Others are the same as above
Double headed hoses are measured in length, 30CM of approximately 28CM braided tubes (stainless steel, aluminium wire, stainless steel bellows, white tube, aluminum wire, outer hose), etc.}40CM is cut to 38CM and so on. The amount of the use of a good knife cut, cut the first set on both sides of the six stainless steel at cap and copper core (iron core, aluminum) into braided tube, so that the hose is made up, but no good.
