Home > categories > Machinery & Equipment > Plastic Injection Machinery > How does the steel injection machine go to the origin?
Question:

How does the steel injection machine go to the origin?

How does the steel injection machine go to the origin?

Answer:

3, with the clamping force of 15% of the set, if the spring die can not be completely closed, or want to reduce the mold contact time, in the range of +-10%, adjust the mold low pressure protection pressure. In the setting of clamping stroke, pressure mold protection must be set by the mold temperature reaches the set value can be accurately set a low voltage protection, because in the cold to be better at the mold temperature reaches the set value of thermal expansion is not locked. 6.2 after the set with A4 (40*40MM) A4 with butter wet paste in the mold safety parting surface, and then clamping voltage protection effect test. If after the mold, the machine will alarm, OK, otherwise reset the low voltage protection parameter until OK.This answer is recommended by users
2, the low voltage protection pressure is set to 0, then the injection molding machine is set to a low pressure hand, repeatedly closed die mold at low pressure required to set the position (the actual position), with low pressure minimum, each increase of 1%, to turn to the low voltage clamping pressure, pressure for low voltage protection we should set.
How to adjust the mould adjusting machine:1, in setting the injection parameters and set the opening, locking stroke, mold protection pressure should have an ideal speed change process, to ensure the safe operation of the mold.

Share to: