Home > categories > Construction & Real Estate > Tile > How hard is it to replace tile?
Question:

How hard is it to replace tile?

I have 12x12 tiles in my kitchen on the floor and about 5 of them are cracked/damaged. How hard is it to replace them, can I do it myslef or hire a professional? What materials will be needed?

Answer:

It's very hard to match the tiles. Also you will have to remove the grout around each broken one, and then crack the broken one into pieces, then remove clean the surface, apply adhesive, and then the tile, and then grout. The color of grout will never match up 100% and neither will the tile. Also it will take you a good part of the day. Good luck with your project!
It's not difficult but it takes some strength and patience. You'll have to break off the damaged tiles and chip the mortar (cement like stuff) until it is flat and even. You can use a chisel for this since it's a small surface. Take out the grout around the tile as well. Then you'll need some mortar, the replacement tile, and grout (color need to match existing grout). Place the prepared mortar on the square using a trowel and lay the tile on it - make sure the tile is even with the existing flooring. If it sinks too low, add mortar, if it pops up too high, take out excess mortar. Then wait 24 hours and then apply the prepared grout over the tile using a rubber float. Scrub clean with wet sponge - might take several times to get the grout film off the tile surface. Wait another 24 hours for the grout to set before walking on it. All done.

Share to: