How is the angle of the aluminum buckle plate installed?
There are L-type and W-type edge, with nails or universal glue directly on the wall.
The vast majority of aluminum buckle plate is installed in the kitchen and bathroom, the walls are tiles,
Usually with universal glue fixed, insurance, and then hit the glass glue, that is no problem.
Aluminum plate is installed in the kitchen and bathroom walls are tiles, there are L-shaped and W-side, with nails or universal glue directly on the wall tiles, and then marked with glass glue, no problem.
A lot of glass mirror sticky.
Ceiling Corner Installation Steps:
1, the four sides of the room required by the actual size of the wall according to the actual size of the wall cut, which have to measure the size of the actual wall according to the actual value of the room.
2, the wall required for the corner line attached to the bottom of the horizontal line, the edge of the line above the level of alignment, and in the side of the line of the hole mark, the distance of 10 ~ 15cm.
3, with a hammer to play 4mm hole, perforation must be accurate to crossed the cross as the center point, the hole depth of about 30cm, in the process of drilling and there is no precise measurement method, so require drilling technology staff Technology to professional.
4, after the hole after the hole, the expansion tube into the hole, the expansion tube shall not exceed the installation of the wall, to ensure that every step in place accurate.
5, according to the angle of the corner, the ends of each corner cut into half of the corner, the standard corner of 90, that is, both ends of the corners cut into 45 degrees, and with 4 * 20 self-tapping screws Corner, fold the edge of the mouth alignment, pay attention to the diagonal angle of the corner, the gap 0.5mm.
6, if the corners must be installed above the tile, you should first install the corners before the installation of wood along the wall, the thickness of the wood and tile and other thick, the surface of the wood and tile surface , The installation method with the installation of the same angle; Note: the installation of the tiles on the tile surface can also be used strong glue, such as 502 glue paste on the tile, so all the fixed wood sliver can be saved.
