How is the concrete mixer cleaned
When the blender is finished, rinse the water immediately, but you can't wash it if you don't clean it immediately
I don't know which type of blender you're talking about. The self-falling mixer is the roller mixer. Rinse directly with water. The strong mode is also the JS mixer water rinse to notice whether the shaft end of the shaft is clean, and be careful not to use the side shovel to break down otherwise there will be a sealing problem
The concrete mixer should pay attention to the following matters: 1, concrete mixer cleaning considerations: Maintain and maintain the maintenance procedure, such as cleaning, lubrication and oil. 2 concrete mixers cleaning attention item two: Concrete mixer start to check all controllers are in good condition, before the shutdown after water and rocks into the mixing barrel within 10 ~ 15 minutes for cleaning, water and Shi Ziqing out again. When the operator is required to go inside the mixer, remove the power supply and remove the fuse and lock the switch box. 3 concrete mixer cleaning considerations: It is forbidden to use sledgehammer to remove concrete from the concrete bowl and only use chisels to remove it. 4, the concrete mixer cleaning attention item 4: After working in the cold season, water cleaning mixer drum and put water accumulation in the water pump, water tank, pipe net, in order to avoid water pump, water tank, pipe freezing, etc.
