How to change the kettle heating plate?
If the electric water heater indicator light does not heat, fault analysis: indicator light, that power line is good, or is the electric sheet metal contact with the electric heater inside the kettle in the base, the electric heater or damage, but is generally more internal fault caused by poor contact, can put the lights out stickers off, exposing the screw down with a screw disassembly, you can open the base panel, and then the three fixed screw base inside the middle of the base down, small screws removed removed, you can see the contact surface of metal sheet and the electric heater, the general poor contact sheet metal will change color, if normally, can be used multimeter electric heater is good, if damaged, to buy a set of electrical appliances market re install on it.
There is an electric kettle without heating, the light is not heated, this estimate is kettle design problems, check to see if the temperature limiter is open not reset. There may be heating disc problems. For example, the heating plate is damaged, the thermostat or temperature fuse, damaged or fever disc internal line damage, resulting in heating plate without electricity.
If the electric kettle through the electric heating plate is not heated, this failure to consider the electric kettle what material is, if it is plastic bottle, general heating plate can be directly replaced; but if it is a stainless steel kettle, electric kettle pot pot estimation of the whole steel are to be scrapped, because heating plate steel is stainless steel welded, no way to replace the heating plate, stainless steel kettle, and the kettle mould some accessories every manufacturers are not the same, so if the electric kettle problems, should return to factory maintenance, re purchase suggestions when buying hot kettle, should pay attention to buy well-known manufacturers of products, such as maintenance it is also easy.
This is not replaceable.The heating wire of the electric kettle is wrapped by aluminum, and it cannot be changed when it is brokenA temperature control device, electric kettle, basic SLD thermostat, SLT thermostat, these types of JIatai thermostat, electric kettle with hot water if it is because of the thermostat failure, replace the same product can be found. If the electric kettle is boiled water, the temperature control switch does not jump, you can know the temperature control switch, and at this time, as long as the replacement of temperature control switch, you can solve the problem.
