Oil slick processing methods: 1. Using the oil slick processor to make the oil slick into the filter, and then using the filtering?cotton in the filter to adsorb, at last decomposing bacteria by nitrobacterium. 2.Collect oil slick in the cup slowly and then dump it. 3. Use oil-absorbing sheet to absorb, put an oil-absorbing sheet at the opposite corner(oil-slick aggregated area) of water outlet to absorb oil slick. 4. Install trumpet funnel commingler to absorb oil slick, mix it with water, and it will be decomposed through absorption by filtering?cotton. 5. pump?up the planted aquarium at night after lights off 6. Remove contamination in the filter.
1. Using the oil slick processor to make the oil slick into the filter, and then using the filtering?cotton in the filter to adsorb, at last decomposing bacteria by nitrobacterium. 2.Collect oil slick in the cup slowly and then dump it. 3. Use oil-absorbing sheet to absorb, put an oil-absorbing sheet at the opposite corner(oil-slick aggregated area) of water outlet to absorb oil slick. 4. Install trumpet funnel commingler to absorb oil slick, mix it with water, and it will be decomposed through absorption by filtering?cotton. 5. Remove contamination in the filter. 6. Feeding fish which lives on oil such as highfin coralfish or black mollyack, which can reduce the film production.
The reasons that there is a layer of oily dirt on the surface of the water: 1. tap water contains small amounts of impurities and organics, after staying in the tank for a period of time, the organics and grease dissolved in water and surfaced. 2. 80% of the algae components are "oils". After the death and rotting of algae, oil would be dissolved in water, and then surfaced. When infusing new water, it will rush out oils attached to the aquatic plants and cylinder wall, and then surfaced to generate oil slick on water surface. 3. Oils generated by wreckage of microorganism or old waste, residual feeds, and other organics. When there is no water flowing, the oil slick is the worst. 4. The filter materials in filters are too dirty so as to spill oil. Influences of water oil dirts: 1. impede exhaust gas or water temperature escaping, give rise to early deterioration of water quality and increase water changes. 2. obstruct light source into water, affecting photosynthesis of plants. Solutions: 1. Using the oil slick processor to make the oil slick into the filter, and then using the filtering?cotton in the filter to adsorb, at last decomposing bacteria by nitrobacterium. 2.Collect oil slick in the cup slowly and then discard it. 3. Use oil-absorbing sheet to absorb, put an oil-absorbing sheet at the opposite corner(oil-slick aggregated area) of water outlet to absorb oil slick. 4. Install trumpet funnel commingler to absorb oil slick, mix it with water, and it will be decomposed through absorption by filtering?cotton. 5. Remove contamination in the filter. 6. Feeding fish which lives on oil such as highfin coralfish or black mollyack, which can reduce the film production. 7. The most recommended and the only way of tackling the problem is to establish a stable biochemical system.
