Home > categories > Construction & Real Estate > Geomembranes > How to install the electrothermal?film non-woven fabrics?
Question:

How to install the electrothermal?film non-woven fabrics?

nan

Answer:

It can be laid on the floor with multi-group parallel connection method. Then install temperature control device, and plug in.
Installation steps of the electrothermal?film non-woven fabrics? Ground leveling first; the first layer: Extruded sheets should be paved on the top of the ground leveling layer; the second layer: Pave floor heating special thermal insulation reflective film; the third layer: Pave electrothermal?film imported from South Korea ; the fourth and fifth layer: Pave two-layer waterproof cloth or non-woven fabric; the sixth layer: Cement pressure plates or a protective plates are paved in the interlayer of the waterproof layers so as to protect electrothermal?film; the seventh layer: Drill 2 to 3 cm cement layer; the eighth layer: Pave floor tile or floor.
After taking ground insulation measures, then clean the ground so as to keep it smooth and flat. Then lay the aluminum foil reflective film, and then pave the electrothermal?film. The electrothermal?film should be face up, and a safe distance between films of around 20 cm is recommended to reserve. Then connect wires and electrothermal?film should be in parallel with wires. Both ends are insulated. Waterproof cloth should be covered after finishing the installation of electrothermal?film.
After taking ground insulation measures, then clean the ground so as to keep it smooth and flat. Then lay the aluminum foil reflective film, and then pave the electrothermal?film. The electrothermal?film should be face up, and a safe distance between films of around 20 cm is recommended to reserve.
It can be laid on the floor with multi-group parallel connection method. Then install temperature control device, and plug in.

Share to: