Home > categories > Lights & Lighting > LED Strips > How to install the LED lamp with the plug?
Question:

How to install the LED lamp with the plug?

How to install the LED lamp with the plug?

Answer:

To make sure all the LED lights are on, cover the cover plate. 6, and finally install the LED light belt.
The plug is connected with the lamp, check; if the light with all the light, congratulations on your good then; if the LED lamp with no light that completely not connected; if the LED lamp with a bright light or a LED lamp with a light meter, or the first m or the last meters is not bright and so on, only then that will not connect the plug.
Open the plastic cover with the plug for the LED light. If you don't turn on the light cover, it's difficult even for professionals to take it, so please don't bother. 3, with the lamp with the quasi light belt lead into the inside of the lamp belt.
Check that the lead of the light port is approximately flush with the port. The distortion of the LED light band may cause the lead of the lamp band to slide relative to the outer plastic part. If the port in the light inside the wire out port, direct plug lamp with plug is easy to cause a short circuit, causing burning lamp with plug even with lights, encounter this kind of situation you will grow a trim to wire port. Be careful. If you cut too much, this meter will be cut off, so you must watch the line cut on the back of the lamp. Don't cut into the inside of the lamp bulb and the lamp with any loop. Be sure to pay attention to the wiring inside the light belt. After you cut the plug, you can light the lamp belt.

Share to: