There are two hoses inside the faucet, I was directly inserted into the hose after the installation, but I see there is a hexagonal screw, is there any other way?
If your hose is screwed into a faucet (with hexagonal) inserted into the faucet, the hexagon can be used in a small open wrench! If the length is not enough to turn the hose only!
If this is the master of the water and electricity will be installed, as for the owner of the hands of the door can be installed need to wrench raw material with the basic things have suggested the choice of stainless steel bellows best life, faucet is also recommended with 304 stainless steel faucet best, faucet and bellows to buy Supporting the equipment, this can consult the people who buy things, according to the product model to install, the general water pipe is hot left cold water on the right, the faucet is the same connection, clear the installation steps like
First, remove the whole copper fixed base.
Second, the nut from the threaded tube counterclockwise rotation down.
Three, hose worn yellow wrench, nut, thread tube, silicone pad.
Four, between the hose through the need to install the vessel (sink, basin, etc.). Note: the silicone pad in the vessel on both sides of the installation of a piece, and finally tighten the fixation can be more stable.
5, the hose of the small head, hand screw into the faucet, screwed to the screw can not move, without the help of other tools to die.
6, the threaded tube screwed into the lower side of the container, the top of the container on the silicone pad at this time can be placed on the lower side of the faucet.
7, nuts fixed faucet, the nut can be tightened, the installation is complete.
