My drinking fountains and bottled water interface part of the overflow, I would like to know is the water dispenser leakage, or bottled water thing, how to judge?
How to solve the leakage of water dispenser?:1, water dispenser faucet water leakageSolution: the valve rod has been pulled out of the water apron, unscrew the valve, take out the apron, the rod inserted back in place.2, smart seat near the leakSolution: the water drinking machine is a lot of hard plastic and soft rubber tube connected by an iron clip, there may be the water machine, wire is loose or damaged. It is recommended that the power plug be removed and that the connections of the pipelines are damaged.3, fresh water leakage after installationSolution: it is recommended to reinstall parts, not connected, it is easy to cause leakage of water dispenser.
4, it is estimated that the floater is broken, it will be good to change a floater.5, first determine whether the water bottle leaks. Change a new bottle to see if it will leak, or wrap a water bottle with a dry towel. If it leaks, it will wet the towel. If the bottle leaks, you should replace the bottle.6. Make sure all connections are okay. Is it leaking due to improper installation after cleaning?. Check each component, including whether the newly purchased bottled water is not compatible with the smart seat connection section. Check this out. Or silica and other components connected with gap or connecting pipe rupture; the silicone tube loose connections, such as nylon buckles (used for fastening the pipe connector) caused by the loosening Water Leakage; hot pot cover and heat between the pot body screw not fastened or loose clearance and Water Leakage. Accessories are not connected, it is easy to cause leakage of water dispenser.7, early design of antimicrobial design, smart seat may be due to one-way valve is bad, resulting in water from the smart seat overflow.
Several possibilities of water leakage in drinking fountains:1 、 the leak point is between the bucket mouth and the bottle cap. All bottled water is repeated filling. In the filling process, the barrel mouth will have a certain degree of wear and tear. Will affect the sealing degree of the bottle cap and barrel mouth. So I suggest changing a bucket of water.2, if not the bucket, you can only change the smart seat. The intake is a mesh at the upper end of the smart seat. Air from the mesh into the sub pool, and then from the smart column into the bucket, the bucket of water and air exchange position, flow into the water dispenser.3, small round hole, is the exhaust. If you do not boil water is not leaking, then change the heating thermostat on the line, and if not boiled water are leaking, then that is the filter, the bottom of the one-way valve is broken, change it.
First, make sure the bucket leaks. The method is to change a new bucket to see if it will leak or to use a dry towel to hold a bucket. If it leaks, it will wet the towel. If the bucket is leaking, a new bucket should be replaced. On the contrary, it may be the contact point of the water fountain and bucket or the water dispenser itself is leaking.
