Home > categories > Machinery & Equipment > Machine Centre > How to set up the CNC vertical machining center
Question:

How to set up the CNC vertical machining center

How to set up the CNC vertical machining center

Answer:

Round the workpiece, to see what to process, and if the surface processing without the angle of the painting can not be found.
The difference between the two values, and then one end of the beat, and finally make the two values the same, to find the right.
For the cube type, you first determine which axis to find a good direction to find points, and then the workpiece to find the surface in the direction of this axis put a little bit with the point, then the lever table to play the other side of the surface, look at this
Usually with a leveraged table to find can also be used to find the edge of the machine

Share to: