The first step: You should measure the size of the glass.The size of the film should match that of the window, in case of wasting the film. Next if you want the film to be perfectly stuck, then you must spray some water to reduce the dust befor sticking the film, creating a dustfree environment for the film. The second step:
Before finhishing washing the glass, you should put a lint free towel under the window to be washed to prevent water from flowing to the outside, thus soaking walls. Cleaning the glass is a important step and it relates to the effect of the film. The third step: When sticking the film, you should spray some water on the both side of the film to remove attachments on the film attched by the static electricity. Then, you can tear off the plastci film on the glass film, spary water on it and stick it on the glass. After that, you can squeeze the the water out and cut needless edges. The fourth step: The final step is to check whether the film has been stuck well. You can check whether edges are firmly attached and whether there are bubbles and wrinkles. Only when it is certain that there is no problem with the film the process of sticking film has been complished.
You can spray water on the glass. It doesn't matter if water flows down. After the film is stuck, bubbles at the bottom is easy to be scrape out with a scraper and it will dry over a period of time. It will be stuck firmly and flat. If there are still bubbles, you can prick it with a needle to release the air.
Spraying evenly a large amount of installing liquid on the whole surface of the glass can enable the film to be stuck on the window naturally and be moved to the right place. Using cutting film guide plate as the guide to cut the window film on the edge can help accurately and evenly cut the redundant the window film window. You can place the plate straightly or at a natural angle on the glass. Then you should cut four sides of the window and leave about 1mm behind. Most importantly, you should complete the cutting before the last extrusion step. After the cutting the edge of the window film, you should spray some liquid on the film once again to clean the installation liquid. Now, you can move to the extrusion step. You should start from the top of the window, press hardly from left to right on the whold glass by the same force and angle, otherwise it will left water stains.
