Home > categories > Construction & Real Estate > Bibcocks > How to water the water heater?
Question:

How to water the water heater?

My home electric water heater connected shower with wash basin, re-clean the water heater after the dirt. I opened the water when the wash basin hot water outlet, cold water pipe began to water heater. Wash basin of hot water pipe began to also water, and later to the exhaust. Finally how water is very small. Finally, almost no water out. Then I turn off the heating. Shower bath with hot water out, but why is the wash basin has been no hot water discharge. Please do the next professional guidance. The book is full of hope Thank you! More

Answer:

It is estimated that the tub of the wash basin is blocked! ~
If the cold water can be released, the hot water can not put, is basically hot water pipe blockage; general hot water received to wash the basin of the basin, if the hot water can not be released, Before the faucet is connected to the front of the triangular valve, and then connected to the basin with a hose to the faucet; you can use the wrench to the root of the triangle valve to open a break, check, test, basically can determine where the block The
The principle of water heater water injection and the principle of hot water out, only in the case of cold water will be out of hot water, there is no cold water into the hot water can not get out, you say the situation, that your family Yao angle difference to carry the hair pipe is normal, is not improper operation.
1, turn off the water heater power supply 2, open a water heater connected to the water nozzle, open to the hottest, until the normal flow of water (not necessarily hot water. Normal flow rate, no jet) 3, turn off a water nozzle, open another Connect the water heater's faucet, the same open to the hottest ,,,, 4, the same method, at the bachelor of the book Yao Yao angle difference to carry all the water heater connected to the water nozzle. After the completion of the water pipe is not exhausted

Share to: