Home > categories > Machinery & Equipment > Other Construction Machinery > I am having a problem with my VSI machinery it stops automatically. (machinery used in the crushing plant)?
Question:

I am having a problem with my VSI machinery it stops automatically. (machinery used in the crushing plant)?

Well the machinery is hydraulic and so it trips automtically after a certain temperature. It is because of the oil or pressure or what. What should I do in order to let it run for longer time. I mean it runs for few minutes.

Answer:

you need to describe your question better. Is the high temp on the hydraulic system or the crusher system? If it is hydraulic, add an oil cooler to the system and depending on the temperature desired it could be an air or water cooler. If it is the crusher, you can lighten the feed rate or open it up a little to let air go through the machine. The other thing look at the set temperature for tripping and make sure the switch is set properly. The other thing is, is the crusher set up right for the material that you are crushing. You may have to adjust the mix of feed or put another crusher in line if you are overloading it. And all crushing is not the same. You can crush aluminum cans by just squeezing them into a block or you can shred them into bits with a shredder/crusher. Not clear what you are doing.

Share to: