Home > categories > Automotive & Motorcycle > Motorcycle Brakes > how much does it cost to get rear brake changed on a gsxr motorcycle)?
Question:

how much does it cost to get rear brake changed on a gsxr motorcycle)?

I‘m looking for the average price ranged for a brake adjustment/replacement for a 03 suzuki gsxr 750

Answer:

Well, they are not adjustable. Do you mean the pads? Caliper? Rotor? Lines or master cylinder? All the above? Can't really pin it down unless you know what it is you need.
GSXR 750's are designed, like each motorcycles, to end on the front brakes – it is the reason there are 2 extensive discs on the front and a tiny one on the returned so the quantity of extremely use in anger (extremely than utilising it for the duration of a hill-start up) ought to be low, then returned wanting alternative at 10,000 km (6200 miles) isn't that undesirable. particularly why you will possibly choose to fasten up the returned is previous me yet doing that is going to placed on the rear brake pads way swifter. the key clarification for brake fade is the fluid boiling because it reaches those temperatures it compresses extra (the extra it could compress, the fewer hydraulic rigidity gets to the pistons interior the caliper); the key clarification for fluid boiling is repeated heavy use, there's a warped rear disc that's inflicting warmth (sarcastically probable brought about via warmth from the pads); if warmth isn't the subject a warped disc will additionally push the pistons returned into the caliper – once you come back to apply it you will ought to depress the lever numerous situations to get rigidity up – it is not brake fade however the rear disc desires to get replaced. to lessen the probabilities of it occurring at an important 2nd base your braking around the front brake and don't ignore engine braking.
The brake pads are about 37 bucks and it only takes less than ten minutes to change them. Just do it yourself. Take the stiff rod off by the caliper--take out the 2 bolts that hold the caliper on--take a small c-clamp and squeeze the pistons back to home--pull out those 2 rods with the little cotter pins--slip in the new pads and re-assemble.Now that wasn't so hard was it? Saved yourself 80 bucks if you would have taken it to the shop.

Share to: