Just boot time, storage time 19 seconds, after running an hour, 35 seconds are stored discontent, machine storage when the storage will stop for a while, what is the reason?When the material storage machine at the start of the normal storage is full, can, after a period of time running storage storage to storage half sit motionless, then stop for a while can move, the normal storage for 19 seconds, not normal discharge time can reach two minutes, sometimes can stop to rest
According to your account, it is likely that the rear end temperature is too high, the feed port is bridged or the material is not broken
Storage material dissatisfaction or storage slow? Or is that the storage slow and storage dissatisfaction ~ ~ ~.Give some solutions for the landlord:1: screw sliding, not blanking. Resulting in a storage or storage, or slow storage. The solution is that all the water above the pipe is opened or a temperature control water valve is added. Control the temperature at the outlet. At some grinding groove is used to mill tube in addition is at outlet of the material, increase the friction. It also prevents the screw from slipping.2: there are debris inside the tube, such as iron or something like that, stuck in it. The only way to deal with it is to check it out.3: pipe and screw wear. Generally, domestic tubes and screws will wear out in a few years. Need replacement. Of course, if you only hit PP, then you don't have to.4: Sol valve leakage or spool stuck. This problem rarely occurs. Change a valve and you'll see.Just think of so many times now, LZ, what kind of situation is it?.
Check whether the change in the value of the storage electronic ruler or encoder is unusual.
Conditions (material temperature / storage pressure, speed / storage start, stop bit, etc.) remain unchanged, respectively, measured when the boot and the hour after the storage stock rotation, to see if it slows down. If so, see if the movements are slow, or, if you check the power source. If not, the storage motor part is not normal (according to the specific type of your material storage device, for example: oil motor, motor drive)If not, the material in the cylinder is abnormal or the chemical composition of the plastic changes.If you have any questions, please feel free to ask them and hope to help you!---------------------------------------------------------------------------------------According to your supplement, the material inlet position is likely to be greater due to the possibility of thermal bridging. Look into the material in the hopper and stir the bar if necessary to see if the feed is normal. If normal, check that the barrel is cooled properly.
