Home > categories > Electrical Equipment & Supplies > Electrical Wires > Installation using electric water heater and toilet wire specifications
Question:

Installation using electric water heater and toilet wire specifications

Ready to exchange water heater, Q: . the toilet socket is 10 An, the wire is aluminum. Is it necessary to replace the socket or wire? If you have to change the line, you can also use the old trunking do not move only? . water heater to buy 1500W a good file or buy ..2000W third gear good? ...2000W third gear water heater can only be heated semi-bile water? How to control the heating of the whole box of water and semi-bile water? More

Answer:

. if you buy the water heater power does not exceed 2000W, then the 10A socket panel do not have to change, aluminum proposed replacement, replaced by 2.5 or 4 square copper wire can not change the line for . pay a single power 1500W You can, a number of stalls is only the difference between the heating time, and the power switch is easier to bad .3 stalls of the water heater has two heating rods, respectively, in the middle of the liner and the bottom of the so-called heating half of the meaning of water Is the above heating rod work, because the hot water density is low, so in the above, the temperature to stop heating, which is heating half gall bladder, the only user is the summer bath with the red, The province of heated whole bile water
1. Floor pavement composite floor (the following do not shop mats or shop 2 cm below the floor mat) The ground is to slot, and then the tank after the tank also use cement powder flat to facilitate the laying of the late floor. Floor flooring (flooring 3 cm above the floor of the mat) the ground can not slot .3 ground flooring solid wood flooring or multi-board (ground loaded keel) the ground can not slot .4. Ground floor tiles can not open the ground The wall of the latex paint the wall must be slotted .6. Wall tile tile wall must be slotted .7. Top of the ceiling tube directly outside the top do not need to slot .8. Top no The top of the ceiling line to be slotted, and the top can not take the PVC pipe.We can use the tape to wrap the wire or directly with the jacket line directly to the top.
You can not, according to your housing construction, if you do not rule out the Ming Ming line can not slot
Do not have to install, concealed part can not open, the use of location, the direction to achieve the purpose of concealed

Share to: