Home > categories > Construction & Real Estate > PVC Ceiling > Long strip pvc buckle ceiling how to dismantle?
Question:

Long strip pvc buckle ceiling how to dismantle?

Installed when the ceiling is not buried hood smoke pipe, now need to demolition of the roof buried, but do not know how to tear down, wait for the master pointing maze. The key to the problem is to know which is the last piece, but do not know how to start

Answer:

To find a less prominent position which can be any, if the time may be aging for a long time, when the demolition of the point will be broken.
This thing did not dry people can not move, there is no on-site guidance, that is not clear.
Hello, long strip pvc buckle plate is so demolished; First of all, you look at the installation of pvc board and repair corners have not hit the glass glue, if hit, it cut it with a knife. And then plug the word screwdriver or utility knife in the last and the penultimate cracks, gently swing up and down, while the last piece of pvc board is loose, you put the board to the left or right side of the corner A push, there will be one side down, and then grabbed the side with both hands, gently down a pressure, slightly with the point of force, a pull, came out. And then dismantling the inside of the board, it is necessary a cross screwdriver, and because each piece of pvc board will be on the tapping of the screw, the first under the self-tapping screws, and then slowly demolition, do not break. Finally, open the pipe hole, first remove the board according to the direction of the release, (must be according to the direction) Oh, and then you need to smoke pipe hole place to mark, and then buy the smoke pipe vertically at the mark , With paint strokes along the smoke pipe a round, and then open the hole hole. Do a good job after the original path installed, surrounded by a good glass glue, on the line. Hope i can help you, huh, huh

Share to: