Followed by the rear wheel is strictly prohibited. Because the loader digging force, the driver is usually in the original soil and stone shovel to dig mountain solid operation process, if improper operation is easy to appear the two rear wheel ground tilt phenomenon. This tilt action landing inertia, will cause the bucket's blade fracture, bucket deformation; rear wheel high when it is also easy to cause the front and back racks and other structural welding cracking, and even plate fracture. Third is strictly prohibited impact heap. Shovel loader ordinary material, you can use the II file operations, it is strictly prohibited to file II file above the orientation of inertial impact pile. The correct method should be when the bucket is close to the material heap, change the gear to I in time, and complete a shovel process.
A lightWhen loading the loader, place the heel firmly against the floor of the cab, parallel the pedals and the accelerator pedal, and gently press the refueling pedal.Two.The loader always keeps the throttle steady during the operation. General operating conditions, the throttle opening at about 70% is appropriate.From threeIn the loader operation, the baseboard should be separated from the brake pedal, flat on the cab floor, and never step on the brake pedal. Loaders often work on uneven job sites. If the foot is always on the brake pedal, the body is running up and down, causing the driver to step on the brake pedal without interest. In general, control the engine conditions and shift gears by controlling the speed of the throttle. This will avoid frequent braking, resulting in overheating of the braking system, but also for the loader to speed up quickly to bring convenience.Four QinIn loader operation, especially in the operation of digging and digging, the bucket should be filled with material under the condition of stable throttle. The cycle pull of the hoisting and turning control lever is called "diligence"". This process is very important and has a great impact on fuel consumption.Five coordinationCoordination is the combination of lifting and bucket handling. Generally, the backhoe process of the loader is to lay the bucket flat on the ground and smoothly to the material pile. When the bucket is parallel to the hopper, the resistance should first follow the principle of first lifting the arm and then receiving the bucket. It can effectively avoid the bucket bottom resistance, which can give full play to the maximum breakout force.Six strictly prohibitedFirst of all, tires are strictly prohibited. When the loader is working, the door will skid when encountering resistance. This phenomenon is usually caused by improper handling by drivers, increasing fuel consumption and damaging the tires.
Four wheel, front wheel not idling must have appropriate load, shovel mouth down, shovel cusp, front wheel, rear wheel should be in a plane, a straight line, the body is placed in the stack, hold the accelerator, the car feel when the load is large should be slowly adding oil, the lifting arm bucket, repeat a few times can. At the beginning of the big arm provided important throttle stability, according to the load point should be increased, to the last full throttle also eat feed plus in the end, this can be judged according to the sound of the engine, if the last bucket up to not eat full, can make the appropriate arm, shovel I never stop!
