Non-lens problem maintenance, the cost is often very low.
So, when you repair the most important thing is to know where the camera is the root, where you have the right to ask the maintenance side to tell you the reasons and maintenance methods, and then determine whether the maintenance costs outrageous.
In addition, according to personal experience, boot LCD display lens error and then automatically retracted to go, this should not be the lens of the action of the gear, so you can exclude the camera did not fall .
There are many reasons for the lens error:
1. The lens itself is a problem:
1. The internal transmission gears between the gears (debris may be the responsibility of consumers - in the camera dust outside the environment using the camera or the lens by the external force after the transmission gear rupture; also may be the camera manufacturer responsibility - in the assembly The lens when the rip fell into the lens, the lens for a long time caused by gear stuck)2. There is a problem with the sensor on the lens (which may be the responsibility of the consumer - the lens of the camera causes the component to be short-circuited, and may be the responsibility of the camera manufacturer - the component fails or falls off)
2. Non-lens issues:
A lot of consumer misunderstanding is the lens error is the lens problem, this wrong view led to unscrupulous maintenance quotes, resulting in expensive camera maintenance costs, because the cost of the lens is very high, in fact, the lens is not all the lens itself is the problem:
1. The lens is through the FPC (that is, we often say that the cable) and the camera board to connect, in order to achieve the purpose of the motherboard drive lens expansion, if the FPC problems, the same lens will be wrong;
2. The motherboard controls the electronic components of the lens problems, the boot will appear lens error words.
