My house building to do the top floor is covered with resin tiles below the wood is fixed, did not do the water on the cover directly to the rainy day to rain, especially under the heavy rain on the leakage of the larger rain along the wall Down the drain, because we are in the countryside are in the local Please do the self-taught artisans do now do not know how the matter is so hard for the rest of my life to do the house now can not live to ask which expert to help our home out of ideas Analyze it
There are problems, you can see my name to search, give you answer Synthetic resin tile installation method: purlins can choose square tube steel (60 * 40 * 3mm) or C steel (100 * 50 * 20 * 3mm) or wood (60 * 40mm), need to do anti-corrosion treatment according to the resin tile type to determine the spacing of purlin (bamboo tile spacing of 750mm), arranged from the bottom up the main tile installed according to the local wind direction reverse installation, two tiles between the horizontal overlap of a crest (including the ridge tile lap) size of 80mm, vertical lap a tile pitch, lap in the purlins contact parts Must be fixed with self-tapping bolts in the case of two slope roof, to be two symmetrical slope of the installation of the slope, in order to facilitate the installation of the corrugated tile is consistent the slope of the torsion tile in the end of the installation of the end of the installation of the torsion bar, is into the ridge tile and the corrugated tile should be dealt with the formation of flattened, so as to be into the three-way ridge tile installation the installation of the ridge when the tile is to avoid the main tile with the seam coincidence to reduce the installation gap fixed for the special self-tapping bolt, the first pad of good bolts and then use the electric wrench moderate tightening, and then cover the water to take
In addition, do you have to install the eaves? You only have to dismantle the resin tile and then reload it again
According to the analysis you said, may be caused by the installation is not standardized, the spacing is too wide, tile lap is not too little overlap? Lap less, then encountered heavy wind and rain, rain is easy to turn into the cause of leakage
