Home > categories > Packaging & Printing > Plastic Film > My house just bought a refrigerator, the box wrapped a layer of plastic protective film, and some have wrinkled, and then pulled down, there are some wrinkle free, whether the need to uncover? Does it bring harm to the cooling of the refrigerator with film?
Question:

My house just bought a refrigerator, the box wrapped a layer of plastic protective film, and some have wrinkled, and then pulled down, there are some wrinkle free, whether the need to uncover? Does it bring harm to the cooling of the refrigerator with film?

My house just bought a refrigerator, the box wrapped a layer of plastic protective film, and some have wrinkled, and then pulled down, there are some wrinkle free, whether the need to uncover? Does it bring harm to the cooling of the refrigerator with film?

Answer:

Remove the plastic film from the refrigerator and heat the refrigerator on both sides of the refrigerator. This film will hinder the cooling of the refrigerator.
Put refrigerators, usually in the refrigerator on both sides reserved 5 to 10 cm distance, the top to set aside 10 cm, the rear should be reserved 10 centimeters of space, so as to help the refrigerator full heat dissipation. Otherwise, the heat of the refrigerator will be stored behind or on both sides of the refrigerator and will not be well lost. In addition, there is a vent around the refrigerator, or a vent that can return to the refrigerator, which allows the heat of the refrigerator to reach the vent.
In addition, refrigerators should not be put together with other household appliances such as stereos, televisions, microwave ovens, etc. the heat generated by these appliances will increase the burden on refrigerators and increase power consumption. Keep away from the heat and avoid direct sunlight because the heat can make the fridge heavier. In short, in the placement problem, must be in line with the refrigerator away from the heat source, the principle of full heat dissipation
Good placement can also effectively reduce noise. The refrigerator placed flat on the ground firmly in place, adjust the balance of the four corners of the bottom, put it in a plane, can also be a refrigerator pad 3-6 cm high and adjust the angle of the four balance box at the bottom of the air convection space increases, reduce noise, in addition to the inspection of the components is not loose, to avoid the occurrence of resonance.

Share to: