No - name intelligent electric pressure cooker failure code
Electric pressure cooker fault code is basically the same, now on the pressure cooker fault code to be a description:
1.E ----- 1 sensor circuit: 1. There may be a sensor circuit, including the lead, plug socket, etc. 2. The weather is too cold, the sensor resistance is too high
Causing the electric pressure cooker to display the code; the processing method can connect a 100K resistor in parallel at both ends of the sensor.
II .E ----- 2 sensor short circuit: sensor short circuit failure is rare. Generally only new (the sensor at 25 degrees room temperature is 100K)
Clean; the second case you have to adjust the pressure switch, as follows:
Adjusting method of pressure switch for electric pressure cooker
There are two methods, 1. hand pressure gauge: add appropriate amount of water to the pot, cover the lid to boil, remove the pressure relief valve marked pressure gauge, etc. table readings rose to
0.068MP when the pressure switch to adjust it just off; with glue fixed adjustment screw. 2. There is no pressure gauge on hand, do not remove the unloading pressure valve, the first pressure
Force to the maximum, and other relief valve just began to leak, immediately adjust the pressure switch to jump, and then clockwise and then spin a little bit on the line. Remember to have to
Fix the screws with glue.
Three .E ----- 3 over-temperature: common is the bottom of the pot is too dirty caused by the temperature is too high
Four .E ----- 4 pressure switch failure: 1. pressure switch electric shock oxidation 2. pressure below 0.04MP on the control of the first case of the oxidation point treatment
